The Astera AX1 Pixel Tube RGB LED Tube Light emits up to 253 lux at 3.3' (5500K) with an integrated battery that is suitable for a variety uses in cine, theatrical, and event productions. The AX1 features 16 individually addressable LED emitters in a 3.4' long tube that you can mount into a set, on a stand, hang from a grid, or even hold in your bare hand. The AX1 features a CRI/TLCI rating of 88, which provides for good color rendition. The fixture can be used to create a soft, direct light on your subject or be used as an accent light as well as a design element in the location or set.





The fixture features five different Dimming Curve modes, as Astera refers to it. Selection of these modes along with the Pulse Width Modulation dimming of the fixture enables flicker-free video shooting. The Pixel Tube features an integrated battery that charges in approximately 7 hours using the included charger and has a run time of 20 hours. It can be controlled remotely by IR, a downloadable app, and wireless DMX. The Pixel Tube has an IP rating of 65 for dust and water ingress, when the rubber plug to cover the charging port is in place. The IP65 rating means the fixture is completely dust tight, and it is impervious to low-pressure jets, which means you can use this fixture in dusty environments and in wet conditions.The AX1 Charging Box from Astera will power 8 AX1 PixelTube integrated batteries in 5 to 7 hours. It accepts 110 to 240 voltage.The Foldable Stand for LED Tube Lights supports Astera AX1, FP1, and FP2 tubes in a vertical position, very close to the floor, for low-angle shooting. The three legs nest together into a compact form for space-efficient packing.An essential accessory for mounting on Super Clamps or any piece of grip gear with female threads, the Baby Pin Double-Ended Spigot from Astera has 1/4"-20 threads at one end and 3/8"-16 threads at the other for mounting onto clamping gear and support lights with a 5/8" receiver. The stainless steel pin is 2.7" long and compatible with the AX3 bracket, AX3 housing, AX5 bracket, AX1 Holder, AX1 Wing Plate, and more.This M5 Eyebolt for Ax1 Pixel, Helios, Titan and Hyperion Tubes from Astera screw into the tube and allow it to be suspended without a frame. They can also be used for suspending four tubes via safety wire.This Metal Holder for Mounting Astera Tubes is used to mount FP1, FP2, and FP3 tubes to walls, truss and other structures. They can can also be secured with spax screws.